Surface treatment and panelling
HANÁK door surface treatment
The quality of surface treatment is incomparable and unique. HANÁK interior doors are treated with varnish in modern rolling up lines from both sides, including the edges. A perfect and the hardest surface is achieved by our UV hardening device. The doors are then treated with varnish on a two-arm robot, the only one of its kind in the Czech Republic. Just compare our surfaces with those of our competitors.
7-layer lacquer PREMIUM
For doors with varnished surfaces we apply five layers of acrylic varnish on both sides of the door, including the edges. This coat is then hardened by UV radiation. After hardening, another two top layers of polyurethane varnish are applied with high gloss or matt. This method results in the most perfect surface treatment of the doors. Its lifetime is almost unlimited and it is absolutely resistant to humidity and high temperatures (up to 500°C). This highest possible standard of gloss cannot be produced by any other technology. As the genuine producers, we are able to supplement the door or repair it with an identical tone of gloss even years later.
For veneer surfaces in matt, we apply four layers on both sides of the door, including the edges, and seven layers of acrylic urethane transparent varnish for high-gloss type. We thus create a perfect functional and aesthetic protection of the veneer. We do not use water-dilutable varnish, because it does not achieve the required resistance. For veneer surfaces, we apply three layers of acrylic urethane transparent varnish in high gloss or matt on both sides of the door and the edges. This creates a perfect functional and aesthetic protection of the veneer. We do not use water-dilutable varnish, because it does not achieve the required resistance. Our state-of-the-art technologies for varnish application and toxic substance incinerator allow us to work only with high-end varnishes based on polyurethane. As a result, we are among the European leaders in the quality of varnished doors.
Benefits and advantages
Unified look of the door and upper metal fitting
The design of the handles is just as important as the design of the door. Besides a wide range of handles in seven surface designs, we can also offer you handles in the same surface design as the door. You will be able to unify the appearance of the metal fitting with the door material or with the whole interior.
Do not spend more money for higher damp resistance. HANÁK interior doors offer it as standard. We never use water-dilutable varnishes, which do not contain the required water resistance, and work only with high-end varnishes based on polyurethane.
High temperature resistance
By using unsuitable varnishes and their poor-quality application, or in case of foil doors based on paper, the temperature shock between two differently heated spaces, for example, can result in door deformation. Thanks to their construction and surface varnish treatment, HANÁK doors have direct temperature resistance up to 500°C.
Glazing variants: Float clear, Satináto matelux, Clear grey Planibel, Matt grey Planibel.
Glazing variants: Clear bronze Planibel, Matt bronze Planibel, Sandblasting negative, Sandblasting positive.
Sandblasting of MILANO and VERONA door glass
Variants: PO01, PO02, PO03, PO04.
Variants: NE01, NE02, NE03, NE04.
For varnished doors, we have introduced a unique method of glazing without the use of glazing strips.